Hey,
I just received my APi but sadly it is not spitting out an HDMI signal. Serial says:
Version 2.18.1263. Copyright (C) 2018 American Megatrends, Inc.
Press <DEL> or <ESC> to enter setup.error: no suitable video mode found.
error: no suitable video mode found.
Booting in blind mode
[ 2.406394] Couldn't get size: 0x800000000000000e
[ 2.411678] MODSIGN: Couldn't get UEFI db list
[ 2.416788] Couldn't get size: 0x800000000000000e
[ 2.422189] Couldn't get size: 0x800000000000000e
[ 2.874524] usb 1-3: string descriptor 0 read error: -22
[ OK ] Started Show Plymouth Boot Screen.
plymouth-start.service
[ OK ] Started Forward Password Requests to Plymouth Directory Watch.
[ OK ] Reached target Local Encrypted Volumes.
[ OK ] Started AppArmor initialization.
apparmor.service
Starting Raise network interfaces...
[ OK ] Started Flush Journal to Persistent Storage.
systemd-journal-flush.service
Starting Create Volatile Files and Directories...
[ OK ] Started Create Volatile Files and Directories.
systemd-tmpfiles-setup.service
Starting Update UTMP about System Boot/Shutdown...
Starting Network Time Synchronization...
Starting Network Name Resolution...
Starting RPC bind portmap service...
[ OK ] Started Update UTMP about System Boot/Shutdown.
systemd-update-utmp.service
[ OK ] Started RPC bind portmap service.
rpcbind.service
[ OK ] Reached target RPC Port Mapper.
[ OK ] Reached target Remote File Systems (Pre).
[ OK ] Reached target Remote File Systems.
[ OK ] Started Network Name Resolution.
[ OK ] Reached target Host and Network Name Lookups.
systemd-resolved.service
[ OK ] Started Network Time Synchronization.
[ OK ] Reached target System Initialization.
systemd-timesyncd.service
[ OK ] Started ACPI Events Check.
[ OK ] Listening on Avahi mDNS/DNS-SD Stack Activation Socket.
Starting Docker Socket for the API.
[ OK ] Listening on ACPID Listen Socket.
[ OK ] Started Daily Cleanup of Temporary Directories.
[ OK ] Started resolvconf-pull-resolved.path.
[ OK ] Listening on CUPS Scheduler.
[FAILED] Failed to start Message of the Day.
See 'systemctl status motd-news.timer' for details.
Starting Socket activation for snappy daemon.
[ OK ] Listening on D-Bus System Message Bus Socket.
[ OK ] Started CUPS Scheduler.
[ OK ] Reached target Paths.
[ OK ] Reached target System Time Synchronized.
[ OK ] Started Discard unused blocks once a week.
[ OK ] Started Trigger anacron every hour.
networking.service
[ OK ] Reached target Timers.
[ OK ] Started Raise network interfaces.
[ OK ] Listening on Docker Socket for the API.
[ OK ] Listening on Socket activation for snappy daemon.
[ OK ] Reached target Sockets.
[ OK ] Reached target Basic System.
[ OK ] Started D-Bus System Message Bus.
dbus.service
Starting Detect the available GPUs and deal with any system changes...
Starting Accounts Service...
[ OK ] Started Atomic Pi XMOS audio chip microphone select line holder.
atomicpi-hold-mic.service
[ OK ] Started Set the CPU Frequency Scaling governor.
ondemand.service
Starting System Logging Service...
Starting WPA supplicant...
Starting Configure EFI to boot the same device on next boot...
Starting SPI GPIO-based custom bus configuration service...
Starting Automatic root filesystem resizer...
Starting Restore /etc/resolv.conf i…fore the ppp link was shut down...
Starting LSB: IPv4 DHCP client with IPv4LL support...
[ OK ] Started ACPI event daemon.
Starting LSB: Start busybox udhcpd at boot time...
[acpid.service
OK ] Started CUPS Scheduler.
cups.service
Starting Login Service...
Starting Dispatcher daemon for systemd-networkd...
Starting LSB: Bluetooth monitoring daemon...
[ OK ] Started Regular background program processing daemon.
cron.service
Starting resolvconf-pull-resolved.service...
Starting LSB: automatic crash report generation...
Starting Initialize hardware monitoring sensors...
Starting Avahi mDNS/DNS-SD Stack...
Starting Modem Manager...
Starting Network Manager...
[ OK ] Started Atomic Pi XMOS audio chip reset line holder[ 5.822296] intel_sst_acpi 808622A8:00: No matching machine driver found
.
atomicpi-hold-xmos.service
Starting LSB: Record successful boot for GRUB...
Starting Disk Manager...
Starting I2C GPIO-based custom bus configuration service...
Starting Snappy daemon...
[ OK ] Started Run anacron jobs.
anacron.service
Starting Save/Restore Sound Card State...
[ OK ] Started System Logging Service.
rsyslog.service
[ OK ] Started SPI GPIO-based custom bus configuration service.
spi-gpio-custom.service
[ OK ] Started Restore /etc/resolv.conf if…before the ppp link was shut down.
[ OK ] Found device /dev/ttyS0.
[ OK ] Started resolvconf-pull-resolved.service.
[ OK ] Started Configure EFI to boot the same device on next boot.
efi-keep-current-boot.service
[ OK ] Started Detect the available GPUs and deal with any system changes.
[ OK ] Started LSB: Start busybox udhcpd at boot time.
udhcpd.service
[ OK ] Started LSB: Bluetooth monitoring daemon.
bluemon.service
[ OK ] Started WPA supplicant.
wpa_supplicant.service
[ OK ] Started Login Service.
systemd-logind.service
[ OK ] Listening on Load/Save RF Kill Switch Status /dev/rfkill Watch.
[ OK ] Started LSB: automatic crash report generation.
apport.service
[ OK ] Started Initialize hardware monitoring sensors.
lm-sensors.service
[ OK ] Started Avahi mDNS/DNS-SD Stack.
avahi-daemon.service
[ OK ] Started Make remote CUPS printers available locally.
cups-browsed.service
i2c-gpio-custom.service
[ OK ] Started I2C GPIO-based custom bus configuration service.
[ OK ] Reached target Sound Card.
Starting Authorization Manager...
[ OK ] Started LSB: Record successful boot for GRUB.
grub-common.service
[ OK ] Started LSB: IPv4 DHCP client with IPv4LL support.
dhcpcd.service
[ OK ] Started Save/Restore Sound Card State.
alsa-restore.service
Starting Load/Save RF Kill Switch Status...
[ OK ] Started Automatic root filesystem resizer.
growroot.service
[ OK ] Started Authorization Manager.
polkit.service
[ OK ] Started Accounts Service.
accounts-daemon.service
[ OK ] Started Modem Manager.
ModemManager.service
Starting Hostname Service...
Starting Bluetooth service...
[ OK ] Started Load/Save RF Kill Switch Status.
systemd-rfkill.service
[ OK ] Started Bluetooth service.
bluetooth.service
[ OK ] Reached target Bluetooth.
[ OK ] Started Disk Manager.
udisks2.service
[ OK ] Started Hostname Service.
systemd-hostnamed.service
tmp-sanity\x2dmountpoint\x2d694792998.mount
NetworkManager.service
[ OK ] Started Network Manager.
Starting Network Manager Wait Online...
[ OK ] Reached target Network.
Starting Permit User Sessions...
Starting OpenBSD Secure Shell server...
Starting containerd container runtime...
Starting Network Manager Script Dispatcher Service...
[ OK ] Started Permit User Sessions.
systemd-user-sessions.service
Starting Light Display Manager...
Starting Hold until boot process finishes up...
[ OK ] Started Snappy daemon.
snapd.service
containerd.service
[ OK ] Started containerd container runtime.
Starting Wait until snapd is fully seeded...
[ OK ] Started Wait until snapd is fully seeded.
snapd.seeded.service
[ OK ] Started Network Manager Script Dispatcher Service.
NetworkManager-dispatcher.service
[ OK ] Started OpenBSD Secure Shell server.
ssh.service
Ubuntu 18.04.1 LTS localhost ttyS0
localhost login:
Is there hope for a solution?
EDIT: https://dlidirect.com/community/champ/forums/1778-atomic-pi-user-forum/topics/7797-system-not-booting-to-hdmi-monitor seems like the same problem.
EDIT2: Tried other monitor works with this one fine. Seems to be an incompatability between the equipment. See: https://dlidirect.com/community/champ/forums/1778-atomic-pi-user-forum/topics/7797-system-not-booting-to-hdmi-monitor
